**For Panels purchased before August 2023** 


Check out this video of best practices to follow when boiling with the Spike Solo! 

 


Boil Control Instructions

  1. Wait until your heating elements are completely covered before flipping elements on.

  2. On the boil kettle only, make sure your PID is set to manual mode. This will allow us to control heating output by percentage instead of actual temperature. This works similar to dialing your gas burner up or down, but on a numeric scale of 0-100.

  3. To move your PID to manual mode, start on the temperature readout screen, and press the Set button 1 time until you arrive on the "AMRS" screen. Click the "Up" button, to change from "auto" to "man" and press Set button 3 times. This will bring you to manual temp screen, and set your output percent.

  4. To start boil, set percentage to 100% (full output). Once you have a rolling boil, drop percentage down to 75% and watch for a boil over. Depending on the strength of your beer (dissolved sugars in the wort) the output can be set as low as 50 or as high as 80 to maintain a good rolling boil without boil over.

  5. To move your PID back to auto mode, start on the temperature readout screen, and press the Set button 3 times until you arrive on the "AMRS" screen. Click the "Up" button, to change from "man" to "auto" and press Set button again.